Translink International

Call us 8:30am - 5:30pm on

+44(0)1746-718740

"Our experience - Your guarantee!"

Washer Accessories

Details: Category: Washer Accessories; Published on 21 July 2014; Written by Administrator; Hits: 84561

Non-Conductive Insulated Wash Hose

	Flexible Pressure Hose
	Construction:
	Inner Tube - Polyethylene Compound
	Braiding - Synthetic
	Cover - Polyurethane compound - Pinpricked
	Colour - Yellow
	Properties - Specially designed for live line washing - Heavy duty, wear resistant - Excellent bend radius - Smooth outer coating allows slip free movement, better than rubber hose. - Lengths of up to 200m

wash-hose-specs

wash-hose-codes

Details: Category: Washer Accessories; Published on 21 July 2014; Written by Administrator; Hits: 112686

Portable Conductivity Meters

Product code: IW 410042

Precision, pocket size meter, hand held Conductivity Meter.
Range 0 – 2,000 Micro mho/cm (micro siemens/cm).
Easy to operate, with modern electronics, and sophisticated measuring techniques.
9v standard replaceable battery with low battery indicator.
High quality accurate linear epoxy Probe.
Fully calibrated prior to despatch.
Supplied in quality robust, heavy-duty carrying case splash proof and giving full protection.
‘Cell K’ Calibration, with simple adjustment, (in the event of damage).
3 position switch, ‘ON’ ‘OFF’ ‘Cell-K’.
Automatic Temperature Compensation (ATC) fitted as standard at 2% °C.
Temperature range 0 to 50 °C.

pcond1

Robust splash-proof case

pcond2

Probe for remote sampling

Details: Category: Washer Accessories; Published on 18 July 2014; Written by Administrator; Hits: 76785

Details: Category: Washer Accessories; Published on 21 July 2014; Written by Administrator; Hits: 78862

Product code: IW 410040

Probe / Sender Unit (located inside the Tank)

Precision built Conductivity Meter.
High quality accurate Epoxy Probe built into the base of the Water Tank.
Easy to operate with Modern Electronics and sophisticated measuring techniques.
Probe fitted with 4m of cable to reach the instruments on the operator control panel.
Water proof, with sealed connection to cable plugs outside the Water Tank.
All cables complete with compatible fittings at each end.
Fully calibrated prior to despatch.
Automatic Temperature Compensation ATC fitted as Standard at 2% °C.
12v (supplied from washer unit).

a) Water Monitor

Clear digital display of water quality in micro mho/cm (micro siemens/cm).
Test button to check Alarm circuit.
If water conductivity increases above the pre-set figure either because of water quality or increase in Temperature, the alarm will sound and the test button lights RED.
Set Point to pre-set water quality.

b) Operator setting controls

Operator selector switch to select 100, 300, 400, 500 Micro Mho/cm (micro siemens/cm), determined by the Operator Manual.
Test button to check the figure at which the water quality has been set. When released the display returns to the actual tank water conductivity.

cond1

Constant Water Monitor

cond2